1) How many Numbers of I/O pins are available in Datalogger?
Datalogger have total 23 I/O pins, which are 8 Channel Analog Input (0=10V), 8 Channel 4-20mA Input, 4 channel Digital inputs, 3 channel Digital Outputs.
2) Does Analog channel works for 0-5 V?
Datalogger comes with 0-10V Analog input but you can use the scaling optiont to scale the values from ninimum to maxmum.
3) What is the maximum Analog/ADC channel available?
8 chaneel 0-10V and 8 Channel 4-20 Ma total 16 channel are available.
4) How do i configfure this Data Logger?
You can use RDL Configuration manager application to configure the data logger.
5) Does Configureable mangers application cost additionjally ?
No, Its comes with free along with data logger.
6) Do you ship this product world Wide?
Yes, We ship this product world wide.
7) Does this 4G Lte Module support world wide service provider carrier / SIM?
Yes, you need to connect our sales team mentioning your Country.
8) How do i test Data logger?
You can use RDL confugartion Manager Application, or your own end application.
9) Does It suppoort JSON and MQTT Protocol?
Yes, It support.
10) Does it Support FTP Protocol?
Yes, It support.
11) Can i use this Product as Edge Node?
Yes, you can use this product as edge node in combination with Idustrail IO module, more info plz refer the applcation diagram.
12) Does it Support MODBUS RTU ? and Device act as master or Slave?
Yes it support moddbus RTU and device act as Master.
13) How many modbus rtu slave can i Connect in one singel bus?
You can connect upo 30 slave device subject to terminal resitnce and distance.
14) Does It Support Modbus TCP ? and Can i configure diffrent polling intervel for Modbus RTU and Modbus TCP?
Yes You configure diffrent polling Intervel, there three diffrent cataogory you can set the polling intervel according to your convience.
15) Max how many modbus register can i configure?
You can configure more than 1200+ register based on application requirements.
16) What is minimum polling Intervel can be set for the device?
1 sec is the minimum ZPolling Intervel you can configurree the device, howver the upload really depends on the uploading server speed and bandwidth and connected device response time.
17) What happen when Network is not Avaialble to upload the data?
It store in SD card.
18) Does Data logger enbled and tested with EMC and EMI Compliance?
Yes, It is tested.
19) Do you support custmize this Data logger according to our requirement?
Yes we do customize, you can touch with our slaes team.
20) What is the Resolution and sampling rate of the Analog Channel?
It is configured for 16 bit and 860 SPS.
21) What are the modbus converion Data types available?
RAW, INTEGER, DOUBLE, BIG-ENDIAN FLOAT, LITTLE ENDIAN FLOAT, MID ENDIAN FLOAT, MID BIG-ENDIAN FLOAT.
22) Does Datalogger supports SSL & which version?
YES, Datalogger supports SSL. version SSLv1, SSLv2, SSLv3, TSLv1, TSLv1.2, TSLv1.3, SSL_TLS.
23) Does Datalogger supports dual SIM?
This device not supporting but we do have another similer product RDL891 enabled with dual sim.
24) Does Data Logger Support ESIM?
This Device Not Supporting But we do have another similer product RDL891 enabled with dual sim.
25) Does Datalogger support remote configure if YES what are the available modes?
YES, data logger supports remote configuration. Ip address suppose to be in the same network.
26) Does this Data logger supports for alaram events.
Yes, you can chose the data logger Model RDL838H / RDL838I.
27) Does this module send SMS trigger a SMS regarding to particular event? if YES how many occurrence & escalation levels it supports.
YES, Alarm can I trigger a SMS regarding a particular event. It will be for multiple occurrences with 5 escalation levels.
28) Does this logger support for sending instruction / command over Modbus/Serial when particular event / alarm triggered.
YES, you can write Modbus/Serial when particular event accurses.
29) Does this Data logger supports enabled with GPS Device?
Yes, you can choose the model RDL 838I.
30) Does WIFI mode support 2.4 or 5GHz?
NO, Datalogger does not support 5 GHz it only supports 2.4GHz.
31) Can I connect PT100 or K/J type Thermocouple Connect directly?
NO, you can choose the other Model.
32) Do I need to code Datalogger?
NO, datalogger is pre-programmed You just need to configure based on your requirement.
33) Does Datalogger comes with the warranty/ guarantee and what are the things included in warranty?
YES, Datalogger comes with the warranty of 1 year.
34) Does Datalogger have inbuilt battery & what is the Backup time?
YES, Datalogger have inbuilt battery.
35) Does Datalogger comes with IP65/IP68 Industrial grade enclosure?
YES, Datalogger comes with IP65/IP68 Industrial grade enclosure.
36) Which are the type of PLC are compatible for communication?
Any MODBUS enabled PLC's.
37) Which is the type of Energy meter being compatible for communication?
Any Branded energy Meter with RS485 RTU Communication.
38) Do have flame prrof enclouse for these data logger?
Yes We do have it, you can refer the model no: RDL890.