Toll-Free Customer Support 24/7

Mini ARM Board-LPC2129 Breadboard Compatible

LPC2129 is a single-chip 32-bit microcontroller with 256KB on-chip Flash ROM with In-System Programming (ISP) and In-Application Programming (IAP) 16KB RAM having Real Time Clock, Watchdog Timer, General purpose I/O pins. CPU clock up to 60 MHz, On-chip crystal oscillator and On-chip PLL. This IC also supports Interrupt Controller, 2 SPI serial interfaces, Two UARTs, I2C serial interface, PWM unit with up to 6 PWM outputs, Two timers (7 capture/compare channels),  4-channels 10bit ADC, 2 CAN channels. 

Order Code : RDL/LPC-29/14/001/V1.0

Questions:

Posted by jojo paul, Saturday, 23 November 2019 on product Mini ARM Board-LPC2129 Breadboard Compatible
  • 0
    vote
    A:

    Yes.

    Please send an email to support@researchdesignlab.com

    Posted by Raghavendra Shetty on Saturday, 23 November 2019
Posted by gopinath, Saturday, 26 September 2015 on product Mini ARM Board-LPC2129 Breadboard Compatible
  • 0
    vote
    A:

    Dear Sir,

    Please use the Keil ID4 complier to program LPC2148

    Posted by Dipti Divakar on Saturday, 26 September 2015
Posted by guru, Friday, 21 August 2015 on product Mini ARM Board-LPC2129 Breadboard Compatible
  • 0
    vote
    A:

    Dear Customer

    Kindly download the driver from below given link,

    http://www.ftdichip.com/Drivers/VCP.htm

     

    Also refer the below video link,

    https://youtu.be/eyoey66EU9w

    Posted by Rashmi P on Friday, 21 August 2015
  • 0
    vote
    A:

    Dear Customer

    Kindly download the driver from below given link,

    http://www.ftdichip.com/Drivers/VCP.htm

     

    Also refer the below video link,

    https://youtu.be/eyoey66EU9w

    Posted by Rashmi P on Friday, 21 August 2015
Posted by shreedhar, Friday, 21 August 2015 on product Mini ARM Board-LPC2129 Breadboard Compatible
  • 0
    vote
    A:

    Dear Sir,

    Please go through the below image, and follow the steps 

     

    1.Connect the MINI USB , make sure DIP switch is ON :

    2.Go-To device manager check the comport selcted for ARM Development board mini USB:

     

     

    3.Open Flash Magic tool, select the appropriate COM port, set the Baud rate to less than or equal to 38400 bps, select device as LPC2148, interface as 'None (ISP)' and oscillator frequency as 12MHz.Click on 'Verify after programming' :

    4:In Auto mode under the 'Options' tab select 'Advanced options'. In this under 'Hardware Config' tab make sure the options 'Use DTR and RTS to control RTS and P0.14' and 'Keep RTS asserted while COM port open' are checked. The values of T1 and T2 are set to 100ms and 200ms by default.


    5:Browse the HEX File :


    6:Click on start button :


    Posted by Admin Admin on Friday, 21 August 2015

Ask Your Question

  • Reload captcha

* Required Fields

Back to top