Toll-Free Customer Support 24/7

ARM Development Board-LPC2148

LPC2148 is a single-chip 32-bit RISC Microcontroller with 512KB on-chip Flash ROM with In-System Programming (ISP) and In-Application Programming (IAP) 32KB RAM having Interrupt Controller, Two 10bit ADCs with 14 channels, USB 2.0 Full Speed Device Controller, Two UARTs, one with full modem interface. Two I2C serial interfaces, Two SPI serial interfaces Two 32-bit timers, Watchdog Timer, PWM unit, Real Time Clock with optional battery backup, Brown out detect circuit General purpose I/O pins. CPU clock up to 60 MHz, On-chip crystal oscillator and On-chip PLL.

Order Code : RDL/LPB-48/14/001/V1.0

Questions:

Posted by gopinath, Saturday, 26 September 2015 on product ARM Development Board-LPC2148
  • 0
    vote
    A:

    Dear Sir,

    Please use the Keil ID4 complier to program LPC2148

    Posted by Dipti Divakar on Saturday, 26 September 2015
Posted by shreedhar, Friday, 21 August 2015 on product ARM Development Board-LPC2148
  • 0
    vote
    A:

    Dear Sir,

    Please go through the below image, and follow the steps 

     

    1.Connect the MINI USB , make sure DIP switch is ON :

    2.Go-To device manager check the comport selcted for ARM Development board mini USB:

     

     

    3.Open Flash Magic tool, select the appropriate COM port, set the Baud rate to less than or equal to 38400 bps, select device as LPC2148, interface as 'None (ISP)' and oscillator frequency as 12MHz.Click on 'Verify after programming' :

    4:In Auto mode under the 'Options' tab select 'Advanced options'. In this under 'Hardware Config' tab make sure the options 'Use DTR and RTS to control RTS and P0.14' and 'Keep RTS asserted while COM port open' are checked. The values of T1 and T2 are set to 100ms and 200ms by default.


    5:Browse the HEX File :


    6:Click on start button :


    Posted by Admin Admin on Friday, 21 August 2015
Posted by ashwin, Monday, 27 July 2015 on product ARM Development Board-LPC2148
  • 0
    vote
    A:

    Dear Customer

    Kindly download the driver from below given link,

    http://www.ftdichip.com/Drivers/VCP.htm

    Also refer the below video link,

    https://youtu.be/eyoey66EU9w

    Posted by Dipti Divakar on Monday, 27 July 2015
Posted by amit, Monday, 27 July 2015 on product ARM Development Board-LPC2148
  • 0
    vote
    A:

    Dear Customer,

    LPC2148 deosn't support CAN protocol

    Posted by Dipti Divakar on Monday, 27 July 2015
Posted by ashwin, Monday, 27 July 2015 on product ARM Development Board-LPC2148
  • 0
    vote
    A:

    Dear Customer,

    Mini USB cable is used for the programming purpose. Kindly use the same.

    Posted by Dipti Divakar on Monday, 27 July 2015

Ask Your Question

  • Reload captcha

* Required Fields

Back to top