L298N Motor Driver Shield IO code 1

/*
* Project name:
L298N Motor Driver Shield
* Copyright
(c) Researchdesignlab.com
* Description:

* Test configuration:
MCU: ATMEGA328
Dev.Board: Arduino uno
Oscillator: 16 MHz
Software: Arduino

*/

int ENA=9; //Connect on Pin 9
int IN1=4; //Connect on Pin 4
int IN2=5; //Connect on Pin 5
int ENB=10; //Connect on Pin 10
int IN3=6; //Connect on Pin 6
int IN4=7; //Connect on Pin 7

void setup() {
pinMode(ENA,OUTPUT);
pinMode(ENB,OUTPUT);
pinMode(IN1,OUTPUT);
pinMode(IN2,OUTPUT);
pinMode(IN3,OUTPUT);
pinMode(IN4,OUTPUT);
digitalWrite(ENA,HIGH);// Activate motor A
digitalWrite(ENB,HIGH);// Activatemotor B
}
void loop(){

digitalWrite(IN1,LOW);
digitalWrite(IN2,HIGH);
digitalWrite(IN3,HIGH);
digitalWrite(IN4,LOW);
delay(1000);
digitalWrite(IN1,LOW);
digitalWrite(IN2,LOW);
digitalWrite(IN3,LOW);
digitalWrite(IN4,LOW);
delay(1000);
digitalWrite(IN1,HIGH);
digitalWrite(IN2,LOW);
digitalWrite(IN3,LOW);
digitalWrite(IN4,HIGH);
delay(1000);
digitalWrite(IN1,LOW);
digitalWrite(IN2,LOW);
digitalWrite(IN3,LOW);
digitalWrite(IN4,LOW);
delay(1000);
}