These are small DC Geared Motors which are very comparable to hobby servos for power, at a fraction of the cost. Perfect for low cost Robotic Kits and applications.

 Order Code : RDL/DCM/13/002/V1.0

The Castor wheel is a type of wheel which is used for most of the robotic applications. Ball caster wheel is an omni directional wheel This wheel can be used as neutral wheel for the robot.

  Order No : RDL/CSW/13/009/V1.0

This module contains no self-locking function, simple implementation, wireless remote control by pressing a key, the receiver output a high level, the corresponding output when key releases. High level at the receiving end disappear, and each channel are independent of each other, each other. The output of high level can directly drive the relay.

ORDER CODE: RDL/4CWR/14/001/V1.0

DB9 ports are very common on most types of microcontroller, where they can be used to communicate with a PC or other serial devices.

Order Code : RDL/DBMP/13/001/V1.0

A DC motor is a mechanically commutated electric motor powered from direct current (DC). The stator is stationary in space by definition and therefore its current. The current in the rotor is switched by the commutator to also be stationary in space. This is how the relative angle between the stator and rotor magnetic flux is maintained near 90 degrees, which generates the maximum torque.

Order Code : RDL/DCM/13/001/V1.0

This is an IC base for 40 Pin IC's. This is used as a place holder for the 40 pin IC chips and is used in order to allow safe removal and insertion of IC chips because IC chips may become damaged from heat due to soldering.This base is very useful for your circuit because if your IC burns out you can easily change the IC without the need of desoldering. 

Order Code : RDL/IB4/13/001/v1.0 

26 Pin FRC Cable with Female connectors at both ends.

 Order Code : RDL/26FRCCBL/13/001/V1.0