Popular Products

The DIY KIT works on the concept of Bluetooth android remote control application, these command so received from any android phone can control robot movement.

As per the commands sent from the sender’s mobile, the microcontroller will send signals the movement of the robot.

ORDER CODE: RDL/DIY-ACBUN/14/001/V1.0

This Book guides the embedded system hobbyist to develop an web based application integrating with Embedded system . Beginner can create custom based HMI or GUI using PHP web application , also you create IOT based application

Integrating PHP with Embedded System

Jump Wires are commonly used with a breadboard, and are used to transfer electrical signals.Very handy for prototyping projects in almost every development boards.

Order Code : RDL/JW/13/001/V1.0

These wheels can be used in various wheeled robots with the motors having 6mm shaft.

 Order No : RDL/WHL/13/002/V1.0

The board has two relay driven by TTL circuit . The board works on 5V but the input signal can come directly from controller output working at 3.3V or 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

Order Code :RDL/2RB5V/13/001/V1.0

2 Keys Keypad can be connected to any microcontroller or any interfacing kit directly. KEY is a small keypad designed to data entries for microcontroller board. The board has 4-pin header for 4-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Order Code : RDL/2SW/14/001/V1.0

A crystal oscillator is an electronic oscillator circuit that uses the mechanical resonance of a vibrating  crystal of piezoelectric material to create an electrical signal with a very precise  frequency.

 Order Code : RDL/MHC/13/001/V1.0