Popular Products
-
The ACS712 provides economical and precise solutions for AC or DC current sensing in industrial, commercial and communication systems. The devise package allows for easy implementation by the customer. The typical application includes motor control, load detection management, switch mode power supplies and over current fault protection. The device is not intended for automotive applications.
Order Code : RDL/CS5/14/001/V2.0
Learn More -
This is a wonderful little SD card interface module. It is easily interfaced as a peripheral to your module. Through programming, you can read and write to the SD card.All SD Card works on 3V interface so if your microcontroller is working on 3V you can use this board readily. The interface board provided is for microcontrollers running at 3V.
Order Code : RDL/SDBB/14/001/V1.0
Learn More -
A crystal oscillator is an electronic oscillator circuit that uses the mechanical resonance of a vibrating crystal of piezoelectric material to create an electrical signal with a very precise frequency.
ORDER CODE: RDL/16MCR/15/001/V1.0
Learn More -
Real Time Clock based on most popular RTC IC DS1307 which can maintain clock & calendar information. Life of 3V battery is 10 years which maintains accurate clock even without any external power. The clock/calendar provides seconds, minutes, hours, day, date, month, and year information. The Interface to board is simple I2C with SCK and SDA pins which can be interfaced with any microcontroller easily.
Order Code : RDL/RTC/13/001/V1.0
Learn More -
Manufacturer Part No:ATMEGA328P-AU
The Atmel® picoPower® ATmega328/P is a low-power CMOS 8-bit microcontroller based on the AVR® enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega328/P achieves throughputs close to 1MIPS per MHz. This empowers system designer to optimize the device for power consumption versus processing speed.
Learn More -
Adapter for standard 32 SSOP SMD Parts to convert to standard 32 Pin DIP size.This SSOP breakout board is a PCB which will interface an SSOP package to 0.1" (2.54mm) headers which can be used on breadboards for prototyping your projects.Simply solder-on your 32-pin SSOP form-factor IC, along with some 0.1-inch-pitch headers, and you will have a usable, breadboard-friendly unit.
Order Code : RDL/BOB/14/001/V2.0
Learn More -
Compatible with all Cellular applications, Antenna used for GSM signal amplification. Customized cable length.Good appearance, Powerful magnetic, Dimensional accuracy, Long lasting life, Optimum insulation resistanceHigh gain, Lower VSWR, Signal stability
Order Code : RDL333
Learn More -
One of the basic interfacing requirements for the hobbyists or electronics enthusiasts is I/P (keypad) and O/P (LCD display) for proyotype applications. This shield uses minimum number I/O’s that is 2 bits(D0 and D1) for LCD data . 5 input key switches (Navigation keys), when it's activated serial data will be sent to pin D0 by internal 2 line LCD controller. Each key has been pulled up to a different voltage level, so a different voltage will be generated every time a user selects a key. This voltage could be read by the analog pin of internal 2 line LCD controller on the board. Hence saves the no of I/O pins. The backlight of the LCD could be controlled by setting PWM (Pin D10) by adding a few lines of code.
Order Code : RDL/LKS/14/001/V1.0
Learn More