Popular Products
-
The components of solar powered intelligent drip irrigation system are shown in Fig. Soil moisture sensor is used for real-time collection of crop root soil moisture content and converting it into a signal in the range of Voltage V; and the signal will transformed as knowledge of water requirement of crop. Soil moisture content at the root zone of different crops is collected by using the soil moisture sensor. The threshold limit for the water requirement for a particular crop has been feed to system which in turn controls the operation the control system. The power needed for the operation of the control system has been met with the use of a solar panel and the display will receive the control signal and display the data stored using the sensor from the field.
ORDER CODE: RDL/DIY-DRAM/14/001/V1.0
Learn More -
Automatic meter reading, or AMR, is the technology of automatically collecting consumption, diagnostic, and status data from energy metering devices (electric) and transferring that data to a central database for billing, troubleshooting, and analyzing. This technology mainly saves utility providers the expense of periodic trips to each physical location to read a meter. Another advantage is that billing can be based on near real-time consumption rather than on estimates based on past or predicted consumption.
ORDER CODE: RDL/DIY-AMRPC/14/001/V1.0
Learn More -
Li-Fi is a plug-and-play evaluation board for developing a wide array of visible light communication applications in consumer, wearable, industrial, medical and Internet of Things (IoT). Li-Fi transfers data from one source to another through visible light without the flickering effect. Technically, 1‟s (LED on) and 0‟s (LED off) are modulated and then transmitted at a very high speed.
ORDER CODE: RDL864
Learn More -
The board can be used in applications where dimming of 110-220V AC power is required like dimming of bulb or fan. The input can be analog signal from microcontroller working at 0-5V or 0-10V which is isolated with the use of opto-couplers.
ORDER CODE: RDL802
Learn More -
24 Channel Opto-Isolated Board is a 24 channel opto-isolator board assembly that allows Raspberry Pi and other logic circuits to be interfaced to input signals that require opto-isolation.This board is helpful for connecting digital systems to a high-voltage or noisy system.
ORDER CODE: RDL708
Learn More -
The I2C-DAC board is a 12-bit digital-to-analog converter device using I2C bus. There are no external components required. Only two signal lines SDA and SCL plus supply voltage and ground are required to be connected. This makes it perfect for embedded systems that require digital-to-analog converter.
ORDER CODE: RDL626
Learn More -
Driver fatigue is a significant factor in a large number of vehicle accidents. The development of technologies for detecting or preventing drowsiness at the wheel is a major challenge in the field of accident avoidance systems. Because of the hazard that drowsiness presents on the road, methods need to be developed for counteracting its affects. The aim of this project is to develop a prototype drowsiness detection system. The focus will be placed on designing a system that will accurately monitor the head movements of a driver in real-time. By monitoring the head movements, it is believed that the symptoms of driver fatigue can be detected early enough to avoid a car accident.
Order Code : RDL/MDD/13/001/V1.0
Learn More -
LCD stands for Liquid Crystal Display. LCD is finding wide spread use replacing LEDs (seven segment LEDs or other multi segment LEDs) because of the the ability to display numbers, characters and graphics. This is in contrast to LEDs, which are limited to numbers and a few characters.
Order Code : RDL/LCD/13/001/V1.0
Learn More