4 Channel Opto-Isolated Board is a 4 channel opto-isolator board assembly that allows microcontroller and other logic circuits to be interfaced to both input and output signals that require opto-isolation.This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system. 

 Order Code : RDL/OPT/13/001/V1.0

LPC2148 is a single-chip 32-bit RISC Microcontroller with 512KB on-chip Flash ROM with In-System Programming (ISP) and In-Application Programming (IAP) 32KB RAM having Interrupt Controller, Two 10bit ADCs with 14 channels, USB 2.0 Full Speed Device Controller, Two UARTs, one with full modem interface.

ORDER CODE: RDL784

It has 4 keys which can be connected to any microcontroller or any interfacing kit directly. KEY is a small key pad designed to data entries for microcontroller board.The board has 6-pin header for 6-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Order Code : RDL/4SW/13/001/V1.1

A very innovative technology known as 'LiFi' or 'Light Fidelity’ or VLC (visible light communication), which transfer the data through light as a medium.

Order Code : RDL/LIFI-T/13/001/V1.0

This adapters allow you to quickly and easily mount a RJ45 connector onto a breadboard or prototype boards. This breakout board brings all 8 pins of its RJ45 socket out to prototyping work. Each pin brought to the male header pins. There are some prototyping area with 0.1" (2.54mm) spacing, allowing easy addition of simple circuits.

Order Code : RDL/RJ45/14/001/V1.0

The board has only one SSR driven by TTL circuit . The board works on 12V but the input signal can come directly from microcontroller output working at 5V to control SSR. Each SSR can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of SSR is indicated by LED.

ORDER CODE: RDL686

Solid State Relays (SSR) are semiconductor equivalents of the electromechanical relay and can be used to control electrical loads without the use of moving parts. The  SSR switch  ON / OFF and  0-100% dimming can be controlled using controller , switches  and PLC logics .This switch can be used control light , FAN, power socket ,  Triac dimming enabled LED's and any other remote  ON / OFF  or dimming application.

ORDER CODE:RDL816