The project aims at designing Home automation system using Wi-Fi technology,you can start with one room or automate the entire house.The system offers one-touch control of lights and appliances.

ORDER CODE: RDL760

A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. Resistors act to reduce current flow, and at the same time, act to lower voltage levels within circuits. In electronic circuits resistors are used to limit current flow, to adjust signal levels, bias active elements, terminate transmission lines among other uses.

Order Code : RDL/RES/13/001/V1.0

This High Quality USB 2.0 cable is perfect for use at home or in the office, easily connecting your device to your computer at high speeds. This cable connects your device for data transfer and syncing while simultaneously charging. The best part is that you can still use your device while charging.

ORDER CODE: RDL756

Automatic meter reading, or AMR, is the technology of automatically collecting consumption, diagnostic, and status data from energy metering devices (electric) and transferring that data to a central database for billing, troubleshooting, and analyzing. This technology mainly saves utility providers the expense of periodic trips to each physical location to read a meter. Another advantage is that billing can be based on near real-time consumption rather than on estimates based on past or predicted consumption. 

ORDER CODE: RDL/DIY-AMRAM/14/001/V1.0

The robot is controlled by a mobile phone that makes call to the mobile phone attached to the robot in the course of the call, if any button is pressed control corresponding to the button pressed is heard at the other end of the call. This tone is called dual tone multi frequency (DTMF).

Order Code : RDL/CPO/13/001/V1.0

A 4x4 matrix keypad requiring eight Input/Output ports for interfacing isused as an example. Rows are connected to Peripheral Input/Output (PIO) pins configured as output. Columns are connected to PIO pins configured as input with interrupts. In this configuration, four pull-up resistors must be added in order to apply a high level on the corresponding input pins.

Note: The color of the PCB may vary. However the circuit/pinout of the PCB will remain same.

Order Code : RDL/4X4KP/13/001/V2.0

This adapters allow you to quickly and easily mount a USB Type A Female connector onto a breadboard or prototype boards. This breakout board brings all 4 pins of its USB Type A Female socket out to prototyping work.Each pin brought to the male header pins. There are some prototyping area with 0.1" (2.54mm) spacing, allowing easy addition of simple circuits.

Order Code : RDL/UBA/14/001/V1.0