It has 8 keys which can be connected to any microcontroller or any interfacing kit directly. KEY is a small key pad designed to data entries for microcontroller board.The board has 10-pin header for 10-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Note: The color of the PCB may vary. However the circuit/pinout of the PCB will remain same.

Order Code : RDL/8SW/13/001/V1.1

4 Channel Opto-Isolated Board is a 4 channel opto-isolator board assembly that allows microcontroller and other logic circuits to be interfaced to both input and output signals that require opto-isolation.This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system. 

 Order Code : RDL/OPT/13/001/V1.0

LPC2148 is a single-chip 32-bit RISC Microcontroller with 512KB on-chip Flash ROM with In-System Programming (ISP) and In-Application Programming (IAP) 32KB RAM having Interrupt Controller, Two 10bit ADCs with 14 channels, USB 2.0 Full Speed Device Controller, Two UARTs, one with full modem interface. Two I2C serial interfaces, Two SPI serial interfaces Two 32-bit timers, Watchdog Timer, PWM unit, Real Time Clock with optional battery backup, Brown out detect circuit General purpose I/O pins. CPU clock up to 60 MHz, On-chip crystal oscillator and On-chip PLL.

Order Code : RDL/LPC-48/14/001/V1.0

This simple board breaks out a female USB type B connector’s VCC, GND, D- and D+ pins to a 0.1" pitch header. The +5V and GND pins can be used to power your project from USB, while the D- and D+ pins give you access to the USB’s differential data signal. 

Order Code : RDL/UBB/14/001/V1.0

It is widely used in electronic,instrumentation,automation,communications,power supply units,student projetcs,amplifiers,medical and wellness devices,test and measurement equipment,industrial control,pheripheral devices and intrfaces, switch boxes.

ORDER CODE: RDL714

Cloud Starter DIY Kit- UNO ATMEGA328

In Machine-to-Machine (M2M) applications, the ability to remotely monitor, collect, store and visualize data is paramount. Clients today have the choice to build out their own back-end server system and associated software elements, or look to a cloud-based system where much of the solution has been provided. Which solution is best depends on many factors including core competency, complexity, capital investment, time to market and more. 

Automatic meter reading, or AMR, is the technology of automatically collecting consumption, diagnostic, and status data from energy metering devices (electric) and transferring that data to a central database for billing, troubleshooting, and analyzing. This technology mainly saves utility providers the expense of periodic trips to each physical location to read a meter. Another advantage is that billing can be based on near real-time consumption rather than on estimates based on past or predicted consumption. 

ORDER CODE: RDL/DIY-AMRAM/14/001/V1.0