Development Board

 This programmer is based on USBasp design and connects to your computer's USB port. Not only is it quite compact, but the design is really elegent. The USB interface is achieved by using an atmega processor and the rest is done in firmware.8051 USB programmer supports 7 Atmel 8051 microcontrollers. It is a reliable tool for fast programming of 8051 devices.

Order Code : RDL/ATB/13/001/V1.0

Atmega Programmer is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed.

Order Code : RDL/AVR/13/001/V1.0

This is a low frequency (125Khz) RFID Reader With serial Output with range 0-10cms. The RFID Reader  is designed specifically for low-frequency (125 kHz) passive tags.Frequency refers to the size of the radio waves used to communicate between the RFID system components.

Order Code :RDL/RFS/15/001/V1.0

LPC2129 is a single-chip 32-bit microcontroller with 256KB on-chip Flash ROM with In-System Programming (ISP) and In-Application Programming (IAP) 16KB RAM having Real Time Clock, Watchdog Timer, General purpose I/O pins.

ORDER CODE: RDL786

LPC2148 is a single-chip 32-bit RISC Microcontroller with 512KB on-chip Flash ROM with In-System Programming (ISP) and In-Application Programming (IAP) 32KB RAM having Interrupt Controller, Two 10bit ADCs with 14 channels, USB 2.0 Full Speed Device Controller, Two UARTs, one with full modem interface.

ORDER CODE: RDL784

Built on the latest Broadcom 2837 ARMv8 64bit processor, the new generation Raspberry Pi 3 Model B is faster and more powerful than its predecessors. With built-in wireless and Bluetooth connectivity, it becomes the ideal IoT ready solution.

ORDER CODE: RDL751

With this board you can develop and prototype with any of Microchip's 40 pin PIC microcontrollers. The RS232 driver on board allows easy connection with PC or other embedded hardware.. The bridge rectifire allow this board to be powered with both AC and DC power supply adapters.

Order Code : RDL/PIC-GB/13/001/V1.0

Motors, Sensor and Actuators interface Trainer Kit, The plug-and-play design that makes it easy for connections and helps Students, hobbyists, enthusiasts, and professionals to build custom Motors, Sensors and Actuator application projects, Motors, Sensor and Actuators interface Trainer Kit equipped with onboard IO’s, Relay, Motors, stepper motor, Servo, sensors and actuators interfaces & peripherals. It’s used in many educational institutions and R&D labs across the world.

Arduino WiFi Adapter Development Board allows an Arduino board to communicate wirelessly using  WiFi or BlueTooth.This shield is build up by two parts: Bluetooth and WiFi shield.This Bluetooth shield is a serial port Bluetooth module (Slave/Master) breakout board. you can directly stack on Arduino and use the UART port for Bluetooth communication.WiFi Shield is an enhanced WiFi modules breakout board for Arduino, it can directly plug in with Arduino, and use any pin of the basic board to connect with the WiFi module serial port.

ORDER CODE: RDL661