Components

A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. Resistors act to reduce current flow, and at the same time, act to lower voltage levels within circuits. In electronic circuits resistors are used to limit current flow, to adjust signal levels, bias active elements, terminate transmission lines among other uses.

Order Code : RDL/RES/13/001/V1.0

A capacitor (originally known as a condenser) is a passive two-terminal electrical component used to store energy electrostatically in an electric field.

Order Code : RDL/CAP/13/001/V1.0

A capacitor (originally known as a condenser) is a passive two-terminal electrical component used to store energy electrostatically in an electric field.An electrolytic capacitor is a capacitor that uses an electrolyte (an ionic conducting liquid) as one of its plates to achieve a larger capacitance per unit 

Order Code : RDL/CAPE/13/001/V1.0

Pull-up resistors are used in electronic logic circuits to ensure that inputs to logic systems settle at expected logic levels, if external devices are disconnected or high-impedance is introduced. They may also be used at the interface between two different types of logic devices, possibly operating at different power supply voltages.A pull-up resistor weakly "pulls" the voltage of the wire it is connected to towards its voltage source level when the other components on the line are inactive.

Order Code : RDL/PUR1K/13/001/V1.0

MC14049UBDR2G Logic, Buffer, MC14049, 3 V to 18 V, SOIC-16

The MC14049UB hex inverter/buffer is constructed with MOS P−channel and N−channel enhancement mode devices in a single monolithic structure. This complementary MOS device finds primary use where low power dissipation and/or high noise immunity is desired. This device provides logic−level conversion using only one supply voltage, VDD. The input−signal high level (VIH) can exceed the VDD supply voltage for logic−level conversions. Two TTL/DTL Loads can be driven when the device is used as CMOS−to−TTL/DTL converters (VDD = 5.0 V, VOL ≤ 0.4 V, IOL ≥ 3.2 mA). Note that pins 13 and 16 are not connected internally on this device; consequently, connections to these terminals will not affect circuit operation.