Components

Manufacturer Part No:ATMEGA328P-AU

The Atmel® picoPower® ATmega328/P is a low-power CMOS 8-bit microcontroller based on the AVR® enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega328/P achieves throughputs close to 1MIPS per MHz. This empowers system designer to optimize the device for power consumption versus processing speed.

MC14049UBDR2G Logic, Buffer, MC14049, 3 V to 18 V, SOIC-16

The MC14049UB hex inverter/buffer is constructed with MOS P−channel and N−channel enhancement mode devices in a single monolithic structure. This complementary MOS device finds primary use where low power dissipation and/or high noise immunity is desired. This device provides logic−level conversion using only one supply voltage, VDD. The input−signal high level (VIH) can exceed the VDD supply voltage for logic−level conversions. Two TTL/DTL Loads can be driven when the device is used as CMOS−to−TTL/DTL converters (VDD = 5.0 V, VOL ≤ 0.4 V, IOL ≥ 3.2 mA). Note that pins 13 and 16 are not connected internally on this device; consequently, connections to these terminals will not affect circuit operation.

ACS712 provides economical and precise solutions for AC or DC current sensing in industrial, commercial, and communications systems. The device package allows for easy implementation by the customer. Typical applications include motor control, load detection and management, switchmode power supplies, and overcurrent fault protection. The device is not intended for automotive applications.

ORDER CODE: RDL/ACS2/15/001/V1.0

Pull-up resistors are used in electronic logic circuits to ensure that inputs to logic systems settle at expected logic levels, if external devices are disconnected or high-impedance is introduced. They may also be used at the interface between two different types of logic devices, possibly operating at different power supply voltages.A pull-up resistor weakly "pulls" the voltage of the wire it is connected to towards its voltage source level when the other components on the line are inactive.

Order Code : RDL/PUR1K/13/001/V1.0

General Purpose Dotted PCB with holes 0.1 inches apart.

Order Code : RDL/GPP/13/001/V1.0

10 Pin FRC Cable with Female connectors at both ends.

 Order Code : RDL/10FRCCBL/13/001/V1.0

26 Pin FRC Cable with Female connectors at both ends.

 Order Code : RDL/26FRCCBL/13/001/V1.0

This is a very small breadboard with 170 tie points. This bread board is compatible with the Arduino Proto Shield, raspberry Pi etc . Strong, self-adhesive backing. Measures 1.8"x1.4".

 Order Code : RDL/MBB/14/001/v1.0

USB Type B connectors, officially referred to asStandard-B connectors, are square in shape with either a slight rounding or large square protrusion on the top, depending on the USB version.

ORDER CODE: RDL/USB-B/15/001/V1.0