LPC2129 is a single-chip 32-bit microcontroller with 256KB on-chip Flash ROM with In-System Programming (ISP) and In-Application Programming (IAP) 16KB RAM having Real Time Clock, Watchdog Timer, General purpose I/O pins. CPU clock up to 60 MHz, On-chip crystal oscillator and On-chip PLL. This IC also supports Interrupt Controller, 2 SPI serial interfaces, Two UARTs, I2C serial interface, PWM unit with up to 6 PWM outputs, Two timers (7 capture/compare channels),  4-channels 10bit ADC, 2 CAN channels. 

Order Code : RDL/LPC-29/14/001/V1.0

This simple board breaks out a female USB type B connector’s VCC, GND, D- and D+ pins to a 0.1" pitch header. The +5V and GND pins can be used to power your project from USB, while the D- and D+ pins give you access to the USB’s differential data signal. 

Order Code : RDL/UBB/14/001/V1.0

This is a simple to use, RS232 to serial base unit for the XBee line. This unit works with all XBee modules including the Series 1 and Series 2.5, standard and Pro version. Plug the unit into the XBee Development Board, attach a RS232 cable, and you will have direct access to the serial and programming pins on the XBee unit.

Order Code : RDL/XSU/14/001/V1.0

Atmega 328 is one of the most commonly used Micro controllers with open source platform amongst many hobbyist and industrial communities. The simplicity and the low power of Atmega 328 helps design many prototype boards which could be used in numerous applications.

ORDER CODE:  RDL/DUF/14/001/V1.0

Atmega 328 is one of the most commonly used Micro controllers with open source platform amongst many hobbyist and industrial communities. The simplicity and the low power of Atmega 328 helps design many prototype boards which could be used in numerous applications.

ORDER CODE: RDL/A38/14/001/V1.0

The PICkit™ 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of microcontrollers

Order Code : RDL/PUZ/14/001/V1.0

The PICki 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of  microcontollers

Order Code : RDL/PUI/14/001/V1.0

A 4x4 matrix keypad requiring eight Input/Output ports for interfacing isused as an example. Rows are connected to Peripheral Input/Output (PIO) pins configured as output. Columns are connected to PIO pins configured as input with interrupts. In this configuration, four pull-up resistors must be added in order to apply a high level on the corresponding input pins.

Note: The color of the PCB may vary. However the circuit/pinout of the PCB will remain same.

Order Code : RDL/4X4KP/13/001/V2.0

Atmega 328 is one of the most commonly used Micro controllers with open source platform amongst many hobbyist and industrial communities. The simplicity and the low power of Atmega 328 helps design many prototype boards which could be used in numerous applications.

Order Code : RDL/RUF/14/001/V1.0