Tin/lead solders, also called soft solders, are commercially available with tin concentrations between 5% and 70% by weight. The greater the tin concentration, the greater the solder’s tensile and shear strengths. Solder Lead is commonly used for electrical soldering and in electrical/electronic work. It has lower melting point.

Order Code : RDL/SOLDERLEAD/13/001/V1.0

General Purpose Dotted PCB with holes 0.1 inches apart.

Order Code : RDL/GPP/13/001/V1.0

A capacitor (originally known as a condenser) is a passive two-terminal electrical component used to store energy electrostatically in an electric field.An electrolytic capacitor is a capacitor that uses an electrolyte (an ionic conducting liquid) as one of its plates to achieve a larger capacitance per unit 

Order Code : RDL/CAPE/13/001/V1.0

A capacitor (originally known as a condenser) is a passive two-terminal electrical component used to store energy electrostatically in an electric field.

Order Code : RDL/CAP/13/001/V1.0

A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. Resistors act to reduce current flow, and at the same time, act to lower voltage levels within circuits. In electronic circuits resistors are used to limit current flow, to adjust signal levels, bias active elements, terminate transmission lines among other uses.

Order Code : RDL/RES/13/001/V1.0

DB9 ports are very common on most types of microcontroller, where they can be used to communicate with a PC or other serial devices.

Order Code : RDL/DBMP/13/001/V1.0

DB9 ports are very common on most types of microcontroller, where they can be used to communicate with a PC or other serial devices.

Order Code : RDL/DBFP/13/001/V1.0

DB9 ports are very common on most types of microcontroller, where they can be used to communicate with a PC or other serial devices.

Order Code : RDL/DBF/13/001/V1.0

This is an IC base for 28 Pin IC's. This is used as a place holder for the 28 pin IC chips and is used in order to allow safe removal and insertion of IC chips because IC chips may become damaged from heat due to soldering.This base is very useful for your circuit because if your IC burns out you can easily change the IC without the need of desoldering. 

Order Code : RDL/28PB/13/001/V1.0