Search results for 'mpq1 s 112d a control relay'

This is a simple to use, RS232 to serial base unit for the XBee line. This unit works with all XBee modules including the Series 1 and Series 2.5, standard and Pro version. Plug the unit into the XBee Development Board, attach a RS232 cable, and you will have direct access to the serial and programming pins on the XBee unit.

Order Code : RDL/XSU/14/001/V1.0

This breakout board bring all 9 pins of a DB9 connector plus a chassis pin out to male header pins and prototyping work.Pefectly use with these female to male jumper wires for breadboard connections. This breakout board isperfect for field wiring tasks and may be mounted to wall box plate or thin panel that has a DB9 cutout.

ORDER CODE: RDL/DB9F/14/001/V1.0

Atmega 328 is one of the most commonly used Micro controllers with open source platform amongst many hobbyist and industrial communities. The simplicity and the low power of Atmega 328 helps design many prototype boards which could be used in numerous applications.

ORDER CODE:  RDL/DUF/14/001/V1.0

Atmega 328 is one of the most commonly used Micro controllers with open source platform amongst many hobbyist and industrial communities. The simplicity and the low power of Atmega 328 helps design many prototype boards which could be used in numerous applications.

ORDER CODE: RDL/A38/14/001/V1.0

The PICkit™ 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of microcontrollers

Order Code : RDL/PUZ/14/001/V1.0

The PICki 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of  microcontollers

Order Code : RDL/PUI/14/001/V1.0

A 4x4 matrix keypad requiring eight Input/Output ports for interfacing isused as an example. Rows are connected to Peripheral Input/Output (PIO) pins configured as output. Columns are connected to PIO pins configured as input with interrupts. In this configuration, four pull-up resistors must be added in order to apply a high level on the corresponding input pins.

Note: The color of the PCB may vary. However the circuit/pinout of the PCB will remain same.

Order Code : RDL/4X4KP/13/001/V2.0

It has 8 keys which can be connected to any microcontroller or any interfacing kit directly. KEY is a small key pad designed to data entries for microcontroller board.The board has 10-pin header for 10-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Note: The color of the PCB may vary. However the circuit/pinout of the PCB will remain same.

Order Code : RDL/8SW/13/001/V1.1

It has 4 keys which can be connected to any microcontroller or any interfacing kit directly. KEY is a small key pad designed to data entries for microcontroller board.The board has 6-pin header for 6-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Order Code : RDL/4SW/13/001/V1.1