Search results for 'Remote Power Management and Meter Reading System Based on ARM microprocesor'

The board can be used in applications where dimming of 110-220V AC power is required like dimming of bulb or fan. The board can be control with a serial data from any microcontroller 0-100% dimming or ON/OFF control.Board also providing an option for connecting bluetooth and controlling tha loads from any smart apps. Mains power (230v) completely isolated from the microcontroller.

Order Code : RDL/3SD/13/001/V1.0

Xbee USB adapter provides easy way for mounting the xbee module and taking the external TTL connection(RX,TX,GND) can be connected to any microcontroller. Power supply can be given to the external or USB.

 Order Code : RDL/XUC/13/001/V1.0

Bidirectional Logic Level Converter is a Four-Channel Device which can be used for Voltage Level Shifting between two devices.The level converter is very easy to use. The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using. High voltage (5V for example) to the 'H' pin, low voltage (3.3V for example) to 'L', and ground from the system to the 'GND' pin.

Order Code : RDL/BLC/13/001/V1.0

Atmega Programmer is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed.

Order Code : RDL/AVR/13/001/V1.0

The AT24CXX EEPROM Board is a storage tool for EEPROM with I2C interface, It is a non-volatile memory module.

Order Code : RDL/EEP/14/001/V1.0

4 Channel Opto-Isolated Board is a 4 channel opto-isolator board assembly that allows microcontroller and other logic circuits to be interfaced to both input and output signals that require opto-isolation.This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system. 

 Order Code : RDL/OPT/13/001/V1.0

Order Code : RDL/12VADP/13/001/V1.0

Serial port bluetooth, Drop-in replacement for wired serial connections, transparent usage. You can use the Bluetooth Module simply for a serial port replacement to establish a connection between MCU and GPS, PC to your embedded project and etc.

Order Code: RDL/MODHC05/13/001/V1.0

Pull-up resistors are used in electronic logic circuits to ensure that inputs to logic systems settle at expected logic levels, if external devices are disconnected or high-impedance is introduced. They may also be used at the interface between two different types of logic devices, possibly operating at different power supply voltages.A pull-up resistor weakly "pulls" the voltage of the wire it is connected to towards its voltage source level when the other components on the line are inactive.

Order Code : RDL/PUR1K/13/001/V1.0