Search results for 'the'

Low Frequency 125kHz RFID Reader with USB/Serial interface with range 0-5 CM. Board level RFID readers can easily integrated with custom build application / solution  via serial communication. Interfacing Wi-Fi module with this serial RFID reader can connect IoT application software, for monitoring and identification.

Order Code : RDL/RRS/14/001/V1.0

The PICkit™ 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of microcontrollers

Order Code : RDL/PUZ/14/001/V1.0

The PICki 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of  microcontollers

Order Code : RDL/PUI/14/001/V1.0

A 4x4 matrix keypad requiring eight Input/Output ports for interfacing isused as an example. Rows are connected to Peripheral Input/Output (PIO) pins configured as output. Columns are connected to PIO pins configured as input with interrupts. In this configuration, four pull-up resistors must be added in order to apply a high level on the corresponding input pins.

Note: The color of the PCB may vary. However the circuit/pinout of the PCB will remain same.

Order Code : RDL/4X4KP/13/001/V2.0

It has 8 keys which can be connected to any microcontroller or any interfacing kit directly. KEY is a small key pad designed to data entries for microcontroller board.The board has 10-pin header for 10-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Note: The color of the PCB may vary. However the circuit/pinout of the PCB will remain same.

Order Code : RDL/8SW/13/001/V1.1

It has 4 keys which can be connected to any microcontroller or any interfacing kit directly. KEY is a small key pad designed to data entries for microcontroller board.The board has 6-pin header for 6-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Order Code : RDL/4SW/13/001/V1.1

2 Keys Keypad can be connected to any microcontroller or any interfacing kit directly. KEY is a small keypad designed to data entries for microcontroller board. The board has 4-pin header for 4-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Order Code : RDL/2SW/14/001/V1.0

Atmega 328 is one of the most commonly used Micro controllers with open source platform amongst many hobbyist and industrial communities. The simplicity and the low power of Atmega 328 helps design many prototype boards which could be used in numerous applications.

Order Code : RDL/RUF/14/001/V1.0

One of the basic interfacing requirements for the hobbyists or electronics enthusiasts is I/P (keypad) and O/P (LCD display)  for proyotype applications. This shield uses minimum number I/O’s that is 4 bits for LCD data and 2 control signal lines for the same. A single analog pin (Pin A0) is multiplexed to read 5 input key switches (Navigation keys). Each key has been pulled up to a different voltage level, so a different voltage will be generated every time a user selects a key. This voltage could be read by the analog pin A0 on the board. Hence saves the no of I/O pins.  The backlight of the LCD could be controlled by setting PWM (Pin D10) by adding a few lines of code.

Order Code : RDL/RLSS/14/001/V1.0