Search results for 'pi'

4 Channel Opto-Isolated Board is a 4 channel opto-isolator board assembly that allows microcontroller and other logic circuits to be interfaced to both input and output signals that require opto-isolation.This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system. 

 Order Code : RDL/OPT/13/001/V1.0

26 Pin FRC Cable with Female connectors at both ends.

 Order Code : RDL/26FRCCBL/13/001/V1.0

10 Pin FRC Cable with Female connectors at both ends.

 Order Code : RDL/10FRCCBL/13/001/V1.0

The board has only one  relay driven by TTL circuit . The board works on 5V but the input signal can come directly from Raspberry Pi and Arduino  output working at 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

 Order Code : RDL/5RR/13/001/V1.0

Jump Wires are commonly used with a breadboard, and are used to transfer electrical signals.Very handy for prototyping projects in almost every development boards.

Order Code : RDL/JW/13/001/V1.0

The PICkit™ 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of microcontrollers

Order Code : RDL/PIK/13/001/V1.0

The ACS712 provides economical and precise solutions for AC or DC current sensing in industrial, commercial and communication systems. The devise package allows for easy implementation by the customer. The typical application includes motor control, load detection management, switch mode power supplies and over current fault protection. The device is not intended for automotive applications.

Order Code : RDL/CUS/13/001/V1.0

This is an IC base for 18 Pin IC's. This base is very useful for your circuit because if your IC burns out you can easily change the IC without the need of desoldering. 

Order Code : RDL/IB18/13/001/v1.0

This is an IC base for 14 Pin IC's. This base is very useful for  circuit because if  IC burns out , you can easily change the IC without the need of desoldering. 

Order Code : RDL/IB14/13/001/v1.0