Search results for 'pcb board china'
-
This programmer is based on USBasp design and connects to your computer's USB port. Not only is it quite compact, but the design is really elegent. The USB interface is achieved by using an atmega processor and the rest is done in firmware. ISP programmer supports Atmel and Atmega microcontrollers. It is a reliable tool for fast programming of Atmel and Atmega devices.Order Code : RDL/ISP-ATG/14/001/V1.0Learn More -
Because the Arduino (and Basic Stamp) are 5V devices, and most modern sensors, displays, flash cards and modes are 3.3V-only, many makers find that they need to perform level shifting/conversion to protect the 3.3V device from 5V.This 8-bit noninverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.2 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.65 V to 5.5 V. This allows for universal low-voltage bidirectional translation between any of the 1.2-V, 1.5-V, 1.8-V, 2.5-V, 3.3-V, and 5-V voltage nodes. VCCA should not exceed VCCB.
Order Code : RDL/8BLC/14/001/V1.0
Learn More -
The PICkit™ 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of microcontrollers
Order Code : RDL/PUZ/14/001/V1.0
Learn More -
The PICki 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of microcontollers
Order Code : RDL/PUI/14/001/V1.0
Learn More -
This double sided pinboard features one side of the patch is 16 pin -60 pin turn DIP, 0.5mm spacing and the other side is 32 pin,44PIN, 64 pin, pitch 0.8mm pitch.
Order Code : RDL/QFP/14/001/V1.0
Learn More -
This is a wonderful little SD card interface module. It is easily interfaced as a peripheral to your module. Through programming, you can read and write to the SD card.All SD Card works on 3V interface.
Order Code : RDL/SDBB5V/14/001/V1.0
Learn More -
The Moisture level of the soil can be detected by this sensor. When the water level is low in the soil, the analog Voltage will be low and this analog voltage keeps increasing as the conductivity between the electrodes in the soil changes. This sensor can be used for watering a flower plantor any other plants requires automation.
Order Code : RDL/ASMS/14/001/V1.0
Learn More -
A very innovative technology known as 'LiFi' or 'Light Fidelity’ or VLC (visible light communication), which transfer the data through light as a medium.
Order Code : RDL/LFS/13/001/V1.0
Learn More -
A very innovative technology known as 'LiFi' or 'Light Fidelity’ or VLC (visible light communication), which transfer the data through light as a medium.
Order Code : RDL/LIFI-T/13/001/V1.0
Learn More -
Atmega Programmer is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed.
Order Code : RDL/AVR/13/001/V1.0
Learn More