Search results for 'mpq1 s 112d a control relay'

The FT245 USB Breakout  Board  is an accessory board that provides a USB to parallel FIFO interface, with FT245 chip onboard.

Order Code : RDL/FTB/14/001/V1.0

The ACS712 provides economical and precise solutions for AC or DC current sensing in industrial, commercial and communication systems. The devise package allows for easy implementation by the customer. The typical application includes motor control, load detection management, switch mode power supplies and over current fault protection. The device is not intended for automotive applications.

Order Code : RDL/CS5/14/001/V2.0

PICs are popular with both industrial developers and hobbyists alike due to their low cost, wide availability, large user base, extensive collection of application notes, availability of low cost or free development tools. They are also commonly used in educational programming .

Order Code : RDL/PIC-U/14/001/V1.0

Due to their low cost, wide availability, large user base and free development tools make PIC Development Boards popular among the Industrial Developers, Educational Programmers and Hobbyists

Order Code : RDL/PDB/14/001/V1.0

The Internet of Things (IoT) is the interconnection of uniquely identifiable embedded computing devices within the existing Internet infrastructure.

Web shield is a smart communication shield for controlling and monitoring embedded application via internet.Internet is the media and economic way for communication between anywhere from to geographical location.This shield is compatible with Arduino open source and make easy way for customized application development.This shield has got four relay 10AMP.The board by ULN2003 IC. The board works on 5V.  

Order Code : RDL/ERS/14/001/V1.0

One of the basic interfacing requirements for the hobbyists or electronics enthusiasts is I/P (keypad) and O/P (LCD display)  for proyotype applications. This shield uses minimum number I/O’s that is 2 bits(D0 and D1) for LCD data . 5 input key switches (Navigation keys), when it's activated serial data will be sent to pin  D0 by internal 2 line LCD controller. Each key has been pulled up to a different voltage level, so a different voltage will be generated every time a user selects a key. This voltage could be read by the analog pin of internal 2 line LCD controller on the board. Hence saves the no of I/O pins.  The backlight of the LCD could be controlled by setting PWM (Pin D10) by adding a few lines of code.

Order Code : RDL/LKS/14/001/V1.0

Low Frequency 125kHz RFID Reader with USB/Serial interface with range 0-5 CM. Board level RFID readers can easily integrated with custom build application / solution  via serial communication. Interfacing Wi-Fi module with this serial RFID reader can connect IoT application software, for monitoring and identification.

Order Code : RDL/RRS/14/001/V1.0

One of the basic interfacing requirements for the hobbyists or electronics enthusiasts is I/P (keypad) and O/P (LCD display)  for proyotype applications. This shield uses minimum number I/O’s that is 4 bits for LCD data and 2 control signal lines for the same. A single analog pin (Pin A0) is multiplexed to read 5 input key switches (Navigation keys). Each key has been pulled up to a different voltage level, so a different voltage will be generated every time a user selects a key. This voltage could be read by the analog pin A0 on the board. Hence saves the no of I/O pins.  The backlight of the LCD could be controlled by setting PWM (Pin D10) by adding a few lines of code.

Order Code : RDL/RLSS/14/001/V1.0