Search results for 'Remote Power Management and Meter Reading System Based on ARM microprocesor'

These relays are suitable for domestic appliance, office machine, audio, equipment, automobile, etc. The relay plays the role as a protector or a circuit switch. It can protect your electric equipment’s very well. 

Order Code : RDL/RPM/13/001/V1.0

Pull-up resistors are used in electronic logic circuits to ensure that inputs to logic systems settle at expected logic levels, if external devices are disconnected or high-impedance is introduced. They may also be used at the interface between two different types of logic devices, possibly operating at different power supply voltages.A pull-up resistor weakly "pulls" the voltage of the wire it is connected to towards its voltage source level when the other components on the line are inactive.

Order Code : RDL/PUR/13/001/V1.0

These RFID cards comes with a range of about 12-15 cm and delivers the processed data very quickly and in a easy readable format. Our range matches with the prevailing requirements of the market and are installed with modern features.

 Order Code : RDL/RFC/13/001/V1.0

Pull-up resistors are used in electronic logic circuits to ensure that inputs to logic systems settle at expected logic levels, if external devices are disconnected or high-impedance is introduced. They may also be used at the interface between two different types of logic devices, possibly operating at different power supply voltages.A pull-up resistor weakly "pulls" the voltage of the wire it is connected to towards its voltage source level when the other components on the line are inactive.

Order Code : RDL/PUR1K/13/001/V1.0

Serial port bluetooth, Drop-in replacement for wired serial connections, transparent usage. You can use the Bluetooth Module simply for a serial port replacement to establish a connection between MCU and GPS, PC to your embedded project and etc.

Order Code: RDL/MODHC05/13/001/V1.0

Order Code : RDL/12VADP/13/001/V1.0

4 Channel Opto-Isolated Board is a 4 channel opto-isolator board assembly that allows microcontroller and other logic circuits to be interfaced to both input and output signals that require opto-isolation.This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system. 

 Order Code : RDL/OPT/13/001/V1.0

The AT24CXX EEPROM Board is a storage tool for EEPROM with I2C interface, It is a non-volatile memory module.

Order Code : RDL/EEP/14/001/V1.0

Atmega Programmer is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed.

Order Code : RDL/AVR/13/001/V1.0