Search results for 'BE5100 Pro 中興晴天 WIFI7 雙2.5GbE 超薄無天線牆面路由器'

This is a wonderful little SD card interface module. It is easily interfaced as a peripheral to your module. Through programming, you can read and write to the SD card.All SD Card works on 3V interface so if your microcontroller is working on 3V you can use this board readily. The interface board provided is for microcontrollers running at 3V.

Order Code : RDL/SDBB/14/001/V1.0

The board has two relay driven by TTL circuit . The board works on 5V but the input signal can come directly from controller output working at 3.3V or 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

Order Code :RDL/2RB5V/13/001/V1.0

This double sided pinboard features one side of the patch is 16 pin -60 pin turn DIP, 0.5mm spacing and the other side is 32 pin,44PIN, 64 pin, pitch 0.8mm pitch.

Order Code : RDL/TQFP/14/001/V1.0

It’s a common high speed IC used to convert USB to serial converter. It’s quite commonly used to connect a microcontroller TTL data to any USB interface host to establish a bridge for communications between USB to serial devices. This particular breakthrough board can be used to program RDL UNO ATMEGA 328 and use directly in to your own circuits. Also this breakthrough board can also act as a bridge between Xbee and its Xbee utility software to configure various Xbee’s.

Order Code : RDL/FTO/14/001/V1.0

One of the basic interfacing requirements for the hobbyists or electronics enthusiasts is I/P (keypad) and O/P (LCD display)  for proyotype applications. This shield uses minimum number I/O’s that is 4 bits for LCD data and 2 control signal lines for the same. A single analog pin (Pin A0) is multiplexed to read 5 input key switches (Navigation keys). Each key has been pulled up to a different voltage level, so a different voltage will be generated every time a user selects a key. This voltage could be read by the analog pin A0 on the board. Hence saves the no of I/O pins.  The backlight of the LCD could be controlled by setting PWM (Pin D10) by adding a few lines of code.

Order Code : RDL/RLSS/14/001/V1.0