Search results for 'pcb board china'
-
It provides high quality recording and playback with 11 Minutes audio at 8 Khz Sampling rate with 16 bit resolution. The aPR33A series C2.x is specially designed for simple key trigger, user can record and playback the message averagely for 1, 2, 4 or 8 voice message(s) by switch, It is suitable in simple interface or need to limit the length of single message.
Order Code : RDL/APR/13/001/V1.0
Learn More -
The PICkit™ 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of microcontrollers
Order Code : RDL/PIK/13/001/V1.0
Learn More -
Jump Wires are commonly used with a breadboard, and are used to transfer electrical signals.Very handy for prototyping projects in almost every development boards.
Order Code : RDL/JW/13/001/V1.0
Learn More -
Order Code : RDL/12VADP/13/001/V1.0
Learn More -
Atmega Programmer is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed.
Order Code : RDL/AVR/13/001/V1.0
Learn More -
A very innovative technology known as 'LiFi' or 'Light Fidelity’ or VLC (visible light communication), which transfer the data through light as a medium.
Order Code : RDL/LIFI-T/13/001/V1.0
Learn More -
A very innovative technology known as 'LiFi' or 'Light Fidelity’ or VLC (visible light communication), which transfer the data through light as a medium.
Order Code : RDL/LFS/13/001/V1.0
Learn More -
The Moisture level of the soil can be detected by this sensor. When the water level is low in the soil, the analog Voltage will be low and this analog voltage keeps increasing as the conductivity between the electrodes in the soil changes. This sensor can be used for watering a flower plantor any other plants requires automation.
Order Code : RDL/ASMS/14/001/V1.0
Learn More -
This is a wonderful little SD card interface module. It is easily interfaced as a peripheral to your module. Through programming, you can read and write to the SD card.All SD Card works on 3V interface.
Order Code : RDL/SDBB5V/14/001/V1.0
Learn More -
This double sided pinboard features one side of the patch is 16 pin -60 pin turn DIP, 0.5mm spacing and the other side is 32 pin,44PIN, 64 pin, pitch 0.8mm pitch.
Order Code : RDL/QFP/14/001/V1.0
Learn More