Search results for 'Remote Power Management and Meter Reading System Based on ARM microprocesor'

Solder-less board.

 Order Code : RDL/BRDB/13/001/V1.0

This is a very small breadboard with 170 tie points. This bread board is compatible with the Arduino Proto Shield, raspberry Pi etc . Strong, self-adhesive backing. Measures 1.8"x1.4".

 Order Code : RDL/MBB/14/001/v1.0

Compatible with all Cellular application, Antenna used for GSM signal amplification. Customized cable length.Good appearance, Powerful magnetic, Dimensional accuracy, Long lasting life, Optimum insulation resistanceHigh gain, Lower VSWR, Signal stability

Order Code : RDL/GSMANT/13/001/V1.0

The Moisture level of the soil can be detected by this sensor. When the water level is low in the soil, the analog Voltage will be low and this analog voltage keeps increasing as the conductivity between the electrodes in the soil changes. This sensor can be used for watering a flower plantor any other plants requires automation.

Order Code : RDL/ASMS/14/001/V1.0

This double sided pinboard features one side of the patch is 16 pin -60 pin turn DIP, 0.5mm spacing and the other side is 32 pin,44PIN, 64 pin, pitch 0.8mm pitch.

Order Code : RDL/QFP/14/001/V1.0

This double sided pinboard features one side of the patch is 16 pin -60 pin turn DIP, 0.5mm spacing and the other side is 32 pin,44PIN, 64 pin, pitch 0.8mm pitch.

Order Code : RDL/TQFP/14/001/V1.0

Arduino Xbee Adapter Development Board allows an Arduino board to communicate wirelessly using  Zigbee or BlueTooth.This shield is build up by two parts: Bluetooth and Xbee shield.This Bluetooth shield is a serial port Bluetooth module (Slave/Master) breakout board. you can directly stack on Arduino and use the UART port for Bluetooth communication.XBee Shield is an enhanced Zigbee XBee Series modules breakout board for Arduino, it can directly plug in with Arduino, and use any pin of the basic board to connect with the XBee module serial port.XBee Shield with Logic Level Converter is an enhanced serial port XBee module breakout board.It can directly plug in with Arduino.

Order Code : RDL/GRS/14/001/V1.0

It’s a common high speed IC used to convert USB to serial converter. It’s quite commonly used to connect a microcontroller TTL data to any USB interface host to establish a bridge for communications between USB to serial devices. This particular breakthrough board can be used to program RDL UNO ATMEGA 328 and use directly in to your own circuits. Also this breakthrough board can also act as a bridge between Xbee and its Xbee utility software to configure various Xbee’s.

Order Code : RDL/FTO/14/001/V1.0

2 Keys Keypad can be connected to any microcontroller or any interfacing kit directly. KEY is a small keypad designed to data entries for microcontroller board. The board has 4-pin header for 4-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Order Code : RDL/2SW/14/001/V1.0