Search results for '4 RELAY BOARD'

Serial port bluetooth, Drop-in replacement for wired serial connections, transparent usage. You can use the Bluetooth Module simply for a serial port replacement to establish a connection between MCU and GPS, PC to your embedded project and etc.

Order Code: RDL/MODHC05/13/001/V1.0

General Purpose Dotted PCB with holes 0.1 inches apart.

Order Code : RDL/GPP/13/001/V1.0

USB2.0 cables provide transfer rates up to 480Mbps, and easily attach to any USB device. A to B cables are used to connect from your USB port on Hub, PC or Mac to your USB device such as printer or scanner.

Order Code : RDL/USBA2B/13/001/V1.0

It provides high quality recording and playback with 11 Minutes audio at 8 Khz Sampling rate with 16 bit resolution. The aPR33A series C2.x is specially designed for simple key trigger, user can record and playback the message averagely for 1, 2, 4 or 8 voice message(s) by switch, It is suitable in simple interface or need to limit the length of single message.

Order Code : RDL/APR/13/001/V1.0

Driver fatigue is a significant factor in a large number of vehicle accidents. The development of technologies for detecting or preventing drowsiness at the wheel is a major challenge in the field of accident avoidance systems. Because of the hazard that drowsiness presents on the road, methods need to be developed for counteracting its affects. The aim of this project is to develop a prototype drowsiness detection system. The focus will be placed on designing a system that will accurately monitor the head movements of a driver in real-time. By monitoring the head movements, it is believed that the symptoms of driver fatigue can be detected early enough to avoid a car accident.

Order Code : RDL/MDDM/13/001/V1.0

The PICkit™ 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of microcontrollers

Order Code : RDL/PIK/13/001/V1.0

Jump Wires are commonly used with a breadboard, and are used to transfer electrical signals.Very handy for prototyping projects in almost every development boards.

Order Code : RDL/JW/13/001/V1.0

Order Code : RDL/12VADP/13/001/V1.0

Atmega Programmer is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed.

Order Code : RDL/AVR/13/001/V1.0