Search results for 'project ideas for cse'

Compatible with all Cellular application, Antenna used for GSM signal amplification. Customized cable length.Good appearance, Powerful magnetic, Dimensional accuracy, Long lasting life, Optimum insulation resistanceHigh gain, Lower VSWR, Signal stability

Order Code : RDL/GSMANT/13/001/V1.0

The Moisture level of the soil can be detected by this sensor. When the water level is low in the soil, the analog Voltage will be low and this analog voltage keeps increasing as the conductivity between the electrodes in the soil changes. This sensor can be used for watering a flower plantor any other plants requires automation.

Order Code : RDL/ASMS/14/001/V1.0

This is a wonderful little SD card interface module. It is easily interfaced as a peripheral to your module. Through programming, you can read and write to the SD card.All SD Card works on 3V interface so if your microcontroller is working on 3V you can use this board readily. The interface board provided is for microcontrollers running at 3V.

Order Code : RDL/SDBB/14/001/V1.0

This is a wonderful little SD card interface module. It is easily interfaced as a peripheral to your module. Through programming, you can read and write to the SD card.All SD Card works on 3V interface.

Order Code : RDL/SDBB5V/14/001/V1.0

The Arduino-Compatible Screw Shield is a terminal expansion board that can be screwed directly to the terminal on the thread and is reliable and convenient. It can be plugged into the Arduino controller. You can use this shield to save yourself from the bad port connection. Feel secure with this arduino-compatible screw shield. It can be used for the robotics and power electronics application circuit.

Order No : RDL/SSB-1/14/001/v1.0

The board has two relay driven by TTL circuit . The board works on 5V but the input signal can come directly from controller output working at 3.3V or 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

Order Code :RDL/2RB5V/13/001/V1.0

Arduino Xbee Adapter Development Board allows an Arduino board to communicate wirelessly using  Zigbee or BlueTooth.This shield is build up by two parts: Bluetooth and Xbee shield.This Bluetooth shield is a serial port Bluetooth module (Slave/Master) breakout board. you can directly stack on Arduino and use the UART port for Bluetooth communication.XBee Shield is an enhanced Zigbee XBee Series modules breakout board for Arduino, it can directly plug in with Arduino, and use any pin of the basic board to connect with the XBee module serial port.XBee Shield with Logic Level Converter is an enhanced serial port XBee module breakout board.It can directly plug in with Arduino.

Order Code : RDL/GRS/14/001/V1.0

It’s a common high speed IC used to convert USB to serial converter. It’s quite commonly used to connect a microcontroller TTL data to any USB interface host to establish a bridge for communications between USB to serial devices. This particular breakthrough board can be used to program RDL UNO ATMEGA 328 and use directly in to your own circuits. Also this breakthrough board can also act as a bridge between Xbee and its Xbee utility software to configure various Xbee’s.

Order Code : RDL/FTO/14/001/V1.0

Order Code :RDL/RFID/14/001/V1.0