Search results for 'ph level'

A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. Resistors act to reduce current flow, and at the same time, act to lower voltage levels within circuits. In electronic circuits resistors are used to limit current flow, to adjust signal levels, bias active elements, terminate transmission lines among other uses.

Order Code : RDL/RES/13/001/V1.0

 This programmer is based on USBasp design and connects to your computer's USB port. Not only is it quite compact, but the design is really elegent. The USB interface is achieved by using an atmega processor and the rest is done in firmware.8051 USB programmer supports 7 Atmel 8051 microcontrollers. It is a reliable tool for fast programming of 8051 devices.

Order Code : RDL/ATB/13/001/V1.0

Serial port bluetooth, Drop-in replacement for wired serial connections, transparent usage. You can use the Bluetooth Module simply for a serial port replacement to establish a connection between MCU and GPS, PC to your embedded project and etc.

Order Code: RDL/MODHC05/13/001/V1.0

USB2.0 cables provide transfer rates up to 480Mbps, and easily attach to any USB device. A to B cables are used to connect from your USB port on Hub, PC or Mac to your USB device such as printer or scanner.

Order Code : RDL/USBA2B/13/001/V1.0

The PICkit™ 2 Development Programmer/Debugger is a low-cost development tool with an easy to use interface for programming and debugging Microchip’s Flash families of microcontrollers

Order Code : RDL/PIK/13/001/V1.0

If you are learning microcontrollers or want to quickly develop embedded solution based on standard 8051 core, this board will help you quick start with the application by giving you access to everything required to run the AT89S52 microcontroller. With this board you can develop and prototype with any of 8051 40 pin microcontrollers. The RS232 driver on board allows easy connection with PC or other embedded hardware . The board have User buttons and status LEDs. The bridge rectifire allow this board to be powered with both AC and DC power supply adapters.

Order Code : RDL/ATR/13/001/V1.0

Atmega Programmer is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed.

Order Code : RDL/AVR/13/001/V1.0

With this board you can develop and prototype with any of Microchip's 40 pin PIC microcontrollers. The RS232 driver on board allows easy connection with PC or other embedded hardware.. The bridge rectifire allow this board to be powered with both AC and DC power supply adapters.

Order Code : RDL/PIC-GB/13/001/V1.0

If you are learning microcontrollers or want to quickly develop embedded solution based on standard 8051 core, this board will help you quick start with the application by giving you access to everything required to run the AT89S52 microcontroller. With this board you can develop and prototype with any of 8051 40 pin microcontrollers.The board have User buttons and status LEDs.

Order Code : RDL/ATMS/14/001/V1.0