Search results for 'ir sensor'

Driver fatigue is a significant factor in a large number of vehicle accidents. The development of technologies for detecting or preventing drowsiness at the wheel is a major challenge in the field of accident avoidance systems. Because of the hazard that drowsiness presents on the road, methods need to be developed for counteracting its affects. The aim of this project is to develop a prototype drowsiness detection system. The focus will be placed on designing a system that will accurately monitor the head movements of a driver in real-time. By monitoring the head movements, it is believed that the symptoms of driver fatigue can be detected early enough to avoid a car accident.

Order Code : RDL/MDDM/13/001/V1.0

Jump Wires are commonly used with a breadboard, and are used to transfer electrical signals.Very handy for prototyping projects in almost every development boards.

Order Code : RDL/JW/13/001/V1.0

The board has only one  relay driven by TTL circuit . The board works on 5V but the input signal can come directly from Raspberry Pi and Arduino  output working at 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

 Order Code : RDL/5RR/13/001/V1.0

4 Channel Opto-Isolated Board is a 4 channel opto-isolator board assembly that allows microcontroller and other logic circuits to be interfaced to both input and output signals that require opto-isolation.This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system. 

 Order Code : RDL/OPT/13/001/V1.0

If you are learning microcontrollers or want to quickly develop embedded solution based on standard 8051 core, this board will help you quick start with the application by giving you access to everything required to run the AT89S52 microcontroller. With this board you can develop and prototype with any of 8051 40 pin microcontrollers. The RS232 driver on board allows easy connection with PC or other embedded hardware . The board have User buttons and status LEDs. The bridge rectifire allow this board to be powered with both AC and DC power supply adapters.

Order Code : RDL/ATR/13/001/V1.0

The board has two relay driven by TTL circuit . The board works on 12V but the input signal can come directly from microcontroller output working at 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

Order Code : RDL/2RB/13/001/V1.0

Atmega Programmer is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed.

Order Code : RDL/AVR/13/001/V1.0

Bidirectional Logic Level Converter is a Four-Channel Device which can be used for Voltage Level Shifting between two devices.The level converter is very easy to use. The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using. High voltage (5V for example) to the 'H' pin, low voltage (3.3V for example) to 'L', and ground from the system to the 'GND' pin.

Order Code : RDL/BLC/13/001/V1.0

With this board you can develop and prototype with any of Microchip's 40 pin PIC microcontrollers. The RS232 driver on board allows easy connection with PC or other embedded hardware.. The bridge rectifire allow this board to be powered with both AC and DC power supply adapters.

Order Code : RDL/PIC-GB/13/001/V1.0