Search results for '4 RELAY BOARD'

Atmega 328 is one of the most commonly used Micro controllers with open source platform amongst many hobbyist and industrial communities. The simplicity and the low power of Atmega 328 helps design many prototype boards which could be used in numerous applications.

ORDER CODE: RDL/A38/14/001/V1.0

Atmega 328 is one of the most commonly used Micro controllers with open source platform amongst many hobbyist and industrial communities. The simplicity and the low power of Atmega 328 helps design many prototype boards which could be used in numerous applications.

ORDER CODE:  RDL/DUF/14/001/V1.0

The FT245 USB Breakout  Board  is an accessory board that provides a USB to parallel FIFO interface, with FT245 chip onboard.

Order Code : RDL/FTB/14/001/V1.0

This is a low frequency (125Khz) RFID Reader With serial Output with range 0-10cms. The RFID Reader  is designed specifically for low-frequency (125 kHz) passive tags.Frequency refers to the size of the radio waves used to communicate between the RFID system components.

Order Code :RDL/RFS/15/001/V1.0

Atmega 328 is one of the most commonly used Micro controllers with open source platform amongst many hobbyist and industrial communities. The simplicity and the low power of Atmega 328 helps design many prototype boards which could be used in numerous applications.

ORDER CODE: RDL658

Arduino WiFi Adapter Development Board allows an Arduino board to communicate wirelessly using  WiFi or BlueTooth.This shield is build up by two parts: Bluetooth and WiFi shield.This Bluetooth shield is a serial port Bluetooth module (Slave/Master) breakout board. you can directly stack on Arduino and use the UART port for Bluetooth communication.WiFi Shield is an enhanced WiFi modules breakout board for Arduino, it can directly plug in with Arduino, and use any pin of the basic board to connect with the WiFi module serial port.

ORDER CODE: RDL661

Arduino Li-Fi Shield is a plug-and-play evaluation board for developing a wide array of visible light communication applications in consumer, wearable, industrial, medical and Internet of Things (IoT). Arduino Li-Fi Shield transfers data from one source to another through visible light without the flickering effect. Technically, 1‟s (LED on) and 0‟s (LED off) are modulated and then transmitted at very high speed.

ORDER CODE: RDL657

The board has only one  relay driven by TTL circuit . The board works on 5V but the input signal can come directly from Raspberry Pi and Arduino  output working at 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

 Order Code : RDL/5RR/13/001/V1.0