Search results for 'usb to uart converter'

Bidirectional Logic Level Converter is a Four-Channel Device which can be used for Voltage Level Shifting between two devices.The level converter is very easy to use. The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using. High voltage (5V for example) to the 'H' pin, low voltage (3.3V for example) to 'L', and ground from the system to the 'GND' pin.

Order Code : RDL/BLC/13/001/V1.0

It’s a common high speed IC used to convert USB to serial converter. It’s quite commonly used to connect a microcontroller TTL data to any USB interface host to establish a bridge for communications between USB to serial devices. This particular breakthrough board can be used to program RDL UNO ATMEGA 328 and use directly in to your own circuits. Also this breakthrough board can also act as a bridge between Xbee and its Xbee utility software to configure various Xbee’s.

Order Code : RDL/FTO/14/001/V1.0

This is a simple to use, RS232 to serial base unit for the XBee line. This unit works with all XBee modules including the Series 1 and Series 2.5, standard and Pro version. Plug the unit into the XBee Development Board, attach a RS232 cable, and you will have direct access to the serial and programming pins on the XBee unit.

Order Code : RDL/XSU/14/001/V1.0

Because the Arduino (and Basic Stamp) are 5V devices, and most modern sensors, displays, flash cards and modes are 3.3V-only, many makers find that they need to perform level shifting/conversion to protect the 3.3V device from 5V.This 8-bit noninverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.2 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.65 V to 5.5 V. This allows for universal low-voltage bidirectional translation between any of the 1.2-V, 1.5-V, 1.8-V, 2.5-V, 3.3-V, and 5-V voltage nodes. VCCA should not exceed VCCB.

Order Code : RDL/8BLC/14/001/V1.0

The MODBUS TCP gateway extends two way communications between the MODBUS RTU & the MODBUS TCP Network. The Gateway comes with Configuration manager that makes device configuration easier.

The MODBUS gateway fetches the Data from a variety of MODBUS Slaves- energy meters, Sensors, industrial PLC’s, and VFD through MODBUS RTU Protocol and then push to MODBUS TCP Scanner device.

ORDER CODE: RDL799

RDL Biometric Add-on Block product is designed to seamlessly integrate with the shop floor machinery. The flexible and customizable design allows you to control various operations like switching machine job operation, downtime escalation, and product loss escalation.

The product is tested with all major PLC vendors and supports multiple interface options.

ORDER CODE: RDL810

 ORDER CODE: RDL812

The Serial RS232 to Ethernet/WiFi gateway extends two way communications between serial terminal host & TCP Network. The Gateway comes with a Configuration manager that makes device configuration easier.
The serial Ethernet / WiFi gateway fetches the Data from a serial terminal host using Open Data method & then pushes to the TCP Scanner device and vice versa.

ORDER CODE:RDL849

Few older devices use DB9 connectors, but most modern computers use USB  port for data transfer. By using a USB to serial adapter, you can continue to use your older serial-enabled device through your new computer's USB port.

 Order Code : RDL/U2U/13/001/V1.0