Search results for 'designe'

ESP32 is a single 2.4 GHz Wi-Fi-and-Bluetooth combo chip designed with the TSMC ultra-low-power 40 nm technology. It is designed to achieve the best power and RF performance, showing robustness, versatility and reliability in a wide variety of applications and power scenarios.

ORDER CODE: RDL818

The series is a custom-designed power modules with high efficiency and small volume,made by Hi-link Electronics company.It has been widely used in smart home, automation and control,communications equipment, instrumentation and other industries.

ORDER CODE: RDL768

The series is a custom-designed power modules with high efficiency and small volume,made by Hi-link Electronics company.It has been widely used in smart home, automation and control,communications equipment, instrumentation And other industries.

ORDER CODE: RDL750

AC-DC Isolated Power Supply Module

ORDER CODE: RDL663

The breadboard power supply kit that takes power from a DC adapter jack  and provide outputs a selectable 1.8V,3.3V,5V,9V,12V and custom adjustable voltage from 0V to 12V.  Breadboard power supply headers are mounted on the bottom of the PCB for simple insertion into a breadboard.

Order Code: RDL617

Because the Arduino (and Basic Stamp) are 5V devices, and most modern sensors, displays, flash cards and modes are 3.3V-only, many makers find that they need to perform level shifting/conversion to protect the 3.3V device from 5V.This 8-bit noninverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.2 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.65 V to 5.5 V. This allows for universal low-voltage bidirectional translation between any of the 1.2-V, 1.5-V, 1.8-V, 2.5-V, 3.3-V, and 5-V voltage nodes. VCCA should not exceed VCCB.

Order Code : RDL/8BLC/14/001/V1.0

It has 8 keys which can be connected to any microcontroller or any interfacing kit directly. KEY is a small key pad designed to data entries for microcontroller board.The board has 10-pin header for 10-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Note: The color of the PCB may vary. However the circuit/pinout of the PCB will remain same.

Order Code : RDL/8SW/13/001/V1.1

It has 4 keys which can be connected to any microcontroller or any interfacing kit directly. KEY is a small key pad designed to data entries for microcontroller board.The board has 6-pin header for 6-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Order Code : RDL/4SW/13/001/V1.1

2 Keys Keypad can be connected to any microcontroller or any interfacing kit directly. KEY is a small keypad designed to data entries for microcontroller board. The board has 4-pin header for 4-wire ribbon cable. By default the switch status would be pulled up, every time you press a key the corresponding switch header changes its state to the common header in the board.

Order Code : RDL/2SW/14/001/V1.0