Search results for 'notei OS'

The board uses BTA12-600B, Triac suitable for general purpose mains power AC switching. They can be used as ON/OFF function in applications such as static relays, heating regulation or induction motor starting circuit. They are also recommended for phase control operations in light dimmers and appliance motors speed controllers.

Order Code : RDL/LDC/13/001/V1.0

The board has only one  relay driven by TTL circuit . The board works on 12V but the input signal can come directly from microcontroller output working at 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

Order Code : RDL/1RB/13/001/V1.0

The board has only one  relay driven by TTL circuit . The board works on 5V but the input signal can come directly from Raspberry Pi and Arduino  output working at 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

 Order Code : RDL/5RR/13/001/V1.0

The AT24CXX EEPROM Board is a storage tool for EEPROM with I2C interface, It is a non-volatile memory module.

Order Code : RDL/EEP/14/001/V1.0

The board has two relay driven by TTL circuit . The board works on 12V but the input signal can come directly from microcontroller output working at 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

Order Code : RDL/2RB/13/001/V1.0

Bidirectional Logic Level Converter is a Four-Channel Device which can be used for Voltage Level Shifting between two devices.The level converter is very easy to use. The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using. High voltage (5V for example) to the 'H' pin, low voltage (3.3V for example) to 'L', and ground from the system to the 'GND' pin.

Order Code : RDL/BLC/13/001/V1.0

This is a wonderful little SD card interface module. It is easily interfaced as a peripheral to your module. Through programming, you can read and write to the SD card.All SD Card works on 3V interface so if your microcontroller is working on 3V you can use this board readily. The interface board provided is for microcontrollers running at 3V.

Order Code : RDL/SDBB/14/001/V1.0

This is a wonderful little SD card interface module. It is easily interfaced as a peripheral to your module. Through programming, you can read and write to the SD card.All SD Card works on 3V interface.

Order Code : RDL/SDBB5V/14/001/V1.0

A 4x4 matrix keypad requiring eight Input/Output ports for interfacing isused as an example. Rows are connected to Peripheral Input/Output (PIO) pins configured as output. Columns are connected to PIO pins configured as input with interrupts. In this configuration, four pull-up resistors must be added in order to apply a high level on the corresponding input pins.

Note: The color of the PCB may vary. However the circuit/pinout of the PCB will remain same.

Order Code : RDL/4X4KP/13/001/V2.0