Search results for 'usb to uart converter'

The board uses BTA12-600B, Triac suitable for general purpose mains power AC switching. They can be used as ON/OFF function in applications such as static relays, heating regulation or induction motor starting circuit. They are also recommended for phase control operations in light dimmers and appliance motors speed controllers.

Order Code : RDL/LDC/13/001/V1.0

LCD stands for Liquid Crystal Display. LCD is finding wide spread use replacing LEDs (seven segment LEDs or other multi segment LEDs) because of the the ability to display numbers, characters and graphics. This is in contrast to LEDs, which are limited to numbers and a few characters.

Order Code : RDL/LCD/13/001/V1.0

The board has only one  relay driven by TTL circuit . The board works on 12V but the input signal can come directly from microcontroller output working at 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

Order Code : RDL/1RB/13/001/V1.0

The regulated power supply accepts unregulated intputs from 12V to 15V AC or DC and gives regulated output of 3.3V  5V and 12V suitable for  projects which needs precise voltage to work. The input can come from step down transformer. Since board has diode  bridge input polarity does not matter.All outputs are brought to screw terminal. There is also an unregulated output voltage to drive high current loads like relays and motors.

It provides high quality recording and playback with 11 Minutes audio at 8 Khz Sampling rate with 16 bit resolution. The aPR33A series C2.x is specially designed for simple key trigger, user can record and playback the message averagely for 1, 2, 4 or 8 voice message(s) by switch, It is suitable in simple interface or need to limit the length of single message.

Order Code : RDL/APR/13/001/V1.0

The board has only one  relay driven by TTL circuit . The board works on 5V but the input signal can come directly from Raspberry Pi and Arduino  output working at 5V to control relays. Each relay can switch varierty of AC or DC high voltage, high current loads working at 110V or 220V AC mains like lights, fans, motors and such. The status of relay is indicated by individual LEDs.

 Order Code : RDL/5RR/13/001/V1.0

4 Channel Opto-Isolated Board is a 4 channel opto-isolator board assembly that allows microcontroller and other logic circuits to be interfaced to both input and output signals that require opto-isolation.This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system. 

 Order Code : RDL/OPT/13/001/V1.0

The AT24CXX EEPROM Board is a storage tool for EEPROM with I2C interface, It is a non-volatile memory module.

Order Code : RDL/EEP/14/001/V1.0

ACS712 provides economical and precise solutions for AC or DC current sensing in industrial, commercial, and communications systems. The device package allows for easy implementation by the customer. Typical applications include motor control, load detection and management, switchmode power supplies, andovercurrent fault protection. The device is not intended for automotive applications.

 Order Code : RDL/CSB/13/001/V1.0