Search results for '4 RELAY BOARD'

Jump Wires are commonly used with a breadboard, and are used to transfer electrical signals.Very handy for prototyping projects in almost every development boards.

Order Code : RDL/JW/13/001/V1.0

USB2.0 cables provide transfer rates up to 480Mbps, and easily attach to any USB device. A to B cables are used to connect from your USB port on Hub, PC or Mac to your USB device such as printer or scanner.

Order Code : RDL/USBA2B/13/001/V1.0

General Purpose Dotted PCB with holes 0.1 inches apart.

Order Code : RDL/GPP/13/001/V1.0

Serial port bluetooth, Drop-in replacement for wired serial connections, transparent usage. You can use the Bluetooth Module simply for a serial port replacement to establish a connection between MCU and GPS, PC to your embedded project and etc.

Order Code: RDL/MODHC05/13/001/V1.0

This is an IC base for 14 Pin IC's. This base is very useful for  circuit because if  IC burns out , you can easily change the IC without the need of desoldering. 

Order Code : RDL/IB14/13/001/v1.0

A capacitor (originally known as a condenser) is a passive two-terminal electrical component used to store energy electrostatically in an electric field.An electrolytic capacitor is a capacitor that uses an electrolyte (an ionic conducting liquid) as one of its plates to achieve a larger capacitance per unit 

Order Code : RDL/CAPE/13/001/V1.0

A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. Resistors act to reduce current flow, and at the same time, act to lower voltage levels within circuits. In electronic circuits resistors are used to limit current flow, to adjust signal levels, bias active elements, terminate transmission lines among other uses.

Order Code : RDL/RES/13/001/V1.0

These RFID cards comes with a range of about 12-15 cm and delivers the processed data very quickly and in a easy readable format. Our range matches with the prevailing requirements of the market and are installed with modern features.

 Order Code : RDL/RFC/13/001/V1.0

This is an IC base for 8 Pin IC's. This base is very useful for your circuit because if your IC burns out you can easily change the IC without the need of desoldering. 

Order Code : RDL/8PB/13/001/V1.0