Search results for 'the'

A crystal oscillator is an electronic oscillator circuit that uses the mechanical resonance of a vibrating  crystal of piezoelectric material to create an electrical signal with a very precise  frequency.

ORDER CODE: RDL/16MCR/15/001/V1.0

USB Type B connectors, officially referred to asStandard-B connectors, are square in shape with either a slight rounding or large square protrusion on the top, depending on the USB version.

ORDER CODE: RDL/USB-B/15/001/V1.0

This is a very small breadboard with 170 tie points. This bread board is compatible with the Arduino Proto Shield, raspberry Pi etc . Strong, self-adhesive backing. Measures 1.8"x1.4".

 Order Code : RDL/MBB/14/001/v1.0

USB2.0 cables provide transfer rates up to 480Mbps, and easily attach to any USB device. A to B cables are used to connect from your USB port on Hub, PC or Mac to your USB device such as printer or scanner.

Order Code : RDL/USBA2B/13/001/V1.0

Tin/lead solders, also called soft solders, are commercially available with tin concentrations between 5% and 70% by weight. The greater the tin concentration, the greater the solder’s tensile and shear strengths. Solder Lead is commonly used for electrical soldering and in electrical/electronic work. It has lower melting point.

Order Code : RDL/SOLDERLEAD/13/001/V1.0

Serial port bluetooth, Drop-in replacement for wired serial connections, transparent usage. You can use the Bluetooth Module simply for a serial port replacement to establish a connection between MCU and GPS, PC to your embedded project and etc.

Order Code: RDL/MODHC05/13/001/V1.0

This is an IC base for 18 Pin IC's. This base is very useful for your circuit because if your IC burns out you can easily change the IC without the need of desoldering. 

Order Code : RDL/IB18/13/001/v1.0

This is an IC base for 14 Pin IC's. This base is very useful for  circuit because if  IC burns out , you can easily change the IC without the need of desoldering. 

Order Code : RDL/IB14/13/001/v1.0

Pull-up resistors are used in electronic logic circuits to ensure that inputs to logic systems settle at expected logic levels, if external devices are disconnected or high-impedance is introduced. They may also be used at the interface between two different types of logic devices, possibly operating at different power supply voltages.A pull-up resistor weakly "pulls" the voltage of the wire it is connected to towards its voltage source level when the other components on the line are inactive.

Order Code : RDL/PUR1K/13/001/V1.0