Search results for 'jumper wire'

Jump Wires are commonly used with a breadboard, and are used to transfer electrical signals.Very handy for prototyping projects in almost every development boards.

ORDER CODE: RDL757

Jump Wires are commonly used with a breadboard, and are used to transfer electrical signals.Very handy for prototyping projects in almost every development boards.

Order Code : RDL/JW/13/001/V1.0

WiFi Antenna with Wire

Order Code : RDL872

Manufacturer Part No:ATMEGA328P-AU

The Atmel® picoPower® ATmega328/P is a low-power CMOS 8-bit microcontroller based on the AVR® enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega328/P achieves throughputs close to 1MIPS per MHz. This empowers system designer to optimize the device for power consumption versus processing speed.

Compatible with all Cellular application, Antenna used for GSM signal amplification. Customized cable length.Good appearance, Powerful magnetic, Dimensional accuracy, Long lasting life, Optimum insulation resistanceHigh gain, Lower VSWR, Signal stability

Order Code : RDL/GSMANT/13/001/V1.0

Pull-up resistors are used in electronic logic circuits to ensure that inputs to logic systems settle at expected logic levels, if external devices are disconnected or high-impedance is introduced. They may also be used at the interface between two different types of logic devices, possibly operating at different power supply voltages.A pull-up resistor weakly "pulls" the voltage of the wire it is connected to towards its voltage source level when the other components on the line are inactive.

Order Code : RDL/PUR1K/13/001/V1.0

Pull-up resistors are used in electronic logic circuits to ensure that inputs to logic systems settle at expected logic levels, if external devices are disconnected or high-impedance is introduced. They may also be used at the interface between two different types of logic devices, possibly operating at different power supply voltages.A pull-up resistor weakly "pulls" the voltage of the wire it is connected to towards its voltage source level when the other components on the line are inactive.

Order Code : RDL/PUR/13/001/V1.0