Search results for 'ir sensor'

WiFi Antenna with Wire

Order Code : RDL872

Manufacturer Part No:ATMEGA328P-AU

The Atmel® picoPower® ATmega328/P is a low-power CMOS 8-bit microcontroller based on the AVR® enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega328/P achieves throughputs close to 1MIPS per MHz. This empowers system designer to optimize the device for power consumption versus processing speed.

MC14049UBDR2G Logic, Buffer, MC14049, 3 V to 18 V, SOIC-16

The MC14049UB hex inverter/buffer is constructed with MOS P−channel and N−channel enhancement mode devices in a single monolithic structure. This complementary MOS device finds primary use where low power dissipation and/or high noise immunity is desired. This device provides logic−level conversion using only one supply voltage, VDD. The input−signal high level (VIH) can exceed the VDD supply voltage for logic−level conversions. Two TTL/DTL Loads can be driven when the device is used as CMOS−to−TTL/DTL converters (VDD = 5.0 V, VOL ≤ 0.4 V, IOL ≥ 3.2 mA). Note that pins 13 and 16 are not connected internally on this device; consequently, connections to these terminals will not affect circuit operation.

Jump Wires are commonly used with a breadboard, and are used to transfer electrical signals.Very handy for prototyping projects in almost every development boards.

ORDER CODE: RDL757

Planar passivated four quadrant triac in a SOT428 (DPAK) surface-mountable plastic package intended for use in general purpose bidirectional switching and phase control applications.

ORDER CODE: RDL731

The PCA9685 is an I2C-bus controlled 16-channel LED controller optimized for Red/Green/Blue/Amber (RGBA) color backlighting applications. Each LED output has its own 12-bit resolution (4096 steps) fixed frequency individual PWM controller that operates at a programmable frequency from a typical of 24 Hz to 1526 Hz with a duty cycle that is adjustable from 0 % to 100 % to allow the LED to be set to a specific brightness value. All outputs are set to the same PWM frequency.

ORDER CODE: RDL630

The aPR33A series are powerful audio processor along with high performance audio analog-to-digital converters (ADCs) and digital-to-analog converters (DACs). The aPR33A series are a fully integrated solution offering high performance and unparalleled integration with analog input, digital processing and analog output functionality. The aPR33A series incorporates all the functionality required to perform demanding audio/voice applications. High quality audio/voice systems with lower bill-of-material costs can be implemented with the aPR33A series because of its integrated analog data converters and full suite of quality-enhancing features such as sample-rate convertor.

ORDER CODE: RDL/APR/15/001/V1.0

A crystal oscillator is an electronic oscillator circuit that uses the mechanical resonance of a vibrating  crystal of piezoelectric material to create an electrical signal with a very precise  frequency.

ORDER CODE: RDL/12MHZ/15/001/V1.0

A crystal oscillator is an electronic oscillator circuit that uses the mechanical resonance of a vibrating  crystal of piezoelectric material to create an electrical signal with a very precise  frequency.

ORDER CODE: RDL/16MCR/15/001/V1.0