Search results for 'ir sensor'

Solder-less board.

 Order Code : RDL/BRDB/13/001/V1.0

Jump Wires are commonly used with a breadboard, and are used to transfer electrical signals.Very handy for prototyping projects in almost every development boards.

Order Code : RDL/JW/13/001/V1.0

Serial port bluetooth, Drop-in replacement for wired serial connections, transparent usage. You can use the Bluetooth Module simply for a serial port replacement to establish a connection between MCU and GPS, PC to your embedded project and etc.

Order Code: RDL/MODHC05/13/001/V1.0

This is an IC base for 18 Pin IC's. This base is very useful for your circuit because if your IC burns out you can easily change the IC without the need of desoldering. 

Order Code : RDL/IB18/13/001/v1.0

This is an IC base for 14 Pin IC's. This base is very useful for  circuit because if  IC burns out , you can easily change the IC without the need of desoldering. 

Order Code : RDL/IB14/13/001/v1.0

Pull-up resistors are used in electronic logic circuits to ensure that inputs to logic systems settle at expected logic levels, if external devices are disconnected or high-impedance is introduced. They may also be used at the interface between two different types of logic devices, possibly operating at different power supply voltages.A pull-up resistor weakly "pulls" the voltage of the wire it is connected to towards its voltage source level when the other components on the line are inactive.

Order Code : RDL/PUR1K/13/001/V1.0

A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. Resistors act to reduce current flow, and at the same time, act to lower voltage levels within circuits. In electronic circuits resistors are used to limit current flow, to adjust signal levels, bias active elements, terminate transmission lines among other uses.

Order Code : RDL/RES/13/001/V1.0

These RFID cards comes with a range of about 12-15 cm and delivers the processed data very quickly and in a easy readable format. Our range matches with the prevailing requirements of the market and are installed with modern features.

 Order Code : RDL/RFC/13/001/V1.0

This is an IC base for 28 Pin IC's. This is used as a place holder for the 28 pin IC chips and is used in order to allow safe removal and insertion of IC chips because IC chips may become damaged from heat due to soldering.This base is very useful for your circuit because if your IC burns out you can easily change the IC without the need of desoldering. 

Order Code : RDL/28PB/13/001/V1.0